Return to the Home Page.

We manufacture the most complete and competitively priced line of lamination pins we know of.

There are basically three styles of pins used in laminations.

DOWEL PINS
 We cannot recommend these because they are "case hardened" (hard on the outside but soft on the inside) and not" through hardened" and therefore they can bend.

However, we have a number of customers that use dowel pins successfully and so we maintain a substantial inventory of 1/4" and 3/16" diameter pins in all the popular lengths.

HIGH TENSILE PINS
 These are "through hardened" pins (60+ on the Rockwell "C" scale), ground to a precise 0.0002" diameter tolerance and manufactured with "centers" (small dimples drilled into the ends to help "center" the punches normally used to remove pins after lamination) unless you instruct us to the contrary.

Once again, we maintain an extensive inventory in both 3/16" and 1/4" diameters in all the popular lengths.
SLOTTED PINS
 These are our 1/4" diameter "High Tensile" pins ground flat on the top and bottom to precisely fit those "slotted" lamination bushings.

 

© 2000 Composite Tool Company   310.538.9898    Fax 800.235.3745     Fax 310.538.5104

Site designed by Creative Link Partners, Inc.